N533CM

This entry covers the specific airframe registered as N533CM, a 2007-built Cessna 525B CitationJet CJ3 with serial number 525B0182. The aircraft is manufactured by Cessna (Textron Aviation) and is owned by HARRISON STEEL CASTINGS CO INC, a corporation based in Attica, IN, US, which serves as the operator/home base for this airframe. The US-registered jet reflects a corporate ownership profile and carries an estimated market valuation of $4,500,000, a figure that highlights its position in the light business jet market and suggests maintained operational condition consistent with active corporate use.

The airframe configured with 8 seats typically supports short- to mid-range corporate missions consistent with an owner/operator profile based in Attica, IN, US. Cabin layout and specific avionics fit are not published here, but as a factory-built Cessna 525B CitationJet CJ3, the aircraft is commonly used for executive transport, business shuttles, and cross-country hops within its 2,040 nm range and at cruise speeds around 417 kts. Maintenance considerations for this specific airframe center on its twin Williams FJ44-3A powerplants, each rated at 2,820 lbf, and the upkeep standards expected under corporate registry; its US registration indicates it operates under applicable U.S. regulatory and maintenance regimes.

The Cessna 525B CitationJet CJ3 occupies the light business jet niche, offering a balance of speed, range, and operating economics appropriate for owner-operated corporations such as HARRISON STEEL CASTINGS CO INC. With a service ceiling of 45,000 ft and a typical cruise near 417 kts, the type competes against other light-cabin jets where buyer and charter demand prioritizes efficiency and regional reach. Resale considerations for this 2007 airframe with serial 525B0182 hinge on airframe and engine time, completion condition, and the documented maintenance history that support its listed valuation of $4,500,000.